3 Search Results

Y₃Fe₅O₁₂ (YIG) thin films are well known for their ferrimagnetic insulating property and low Gilbert damping coefficient (α), allowing them to be used for various spintronic applications and as magneto-optical isolators for photonic devices. Instead of doping, incorporation of plasmonic metals as nanoinclusions could be a promising route for improved magneto-optical coupling properties. In this work, YIG–Au nanocomposites have been deposited with ferrimagnetic insulating YIG as the matrix and Au nanoinclusions which introduce plasmonic absorption, optical anisotropy, and hyperbolic properties. Films with varying Au nanoinclusion densities have been processed and annealed to compare with the as-deposited ones. The films thatmore » had low Au nanoinclusion density and were annealed presented a lower magnetic damping coefficient of 2.84 × 10⁻⁴ than the pure YIG film (9.66 × 10⁻⁴). The as-deposited film with the highest Au density shows the strongest hyperbolic properties among all samples. These results demonstrate that both magnetic damping and optical properties can be tuned through deposition conditions in YIG–Au nanocomposite thin films, allowing for a balance of both properties. This YIG–Au nanocomposite system presents promising potential in next-generation opto-spintronic devices.« less

The demonstration of epitaxial thin film transfer has enormous potential for thin film devices free from the traditional substrate epitaxy limitations. However, large-area continuous film transfer remains a challenge for the commonly reported polymer-based transfer methods due to bending and cracking during transfer, especially for highly strained epitaxial thin films. In this work, a new epoxy-based, rigid transfer method is used to transfer films from an SrTiO₃ (STO) growth substrate onto various new substrates, including those that will typically pose significant problems for epitaxy. An epitaxial multiferroic Bi₃Fe₂Mn₂O_x (BFMO) layered supercell (LSC) material is selected as the thin film formore » this demonstration. The results of surface and structure studies show an order of magnitude increase in the continuous area of transferred films when compared to previous transfer methods. The magnetic properties of the BFMO LSC films are shown to be enhanced by the release of strain in this method, and ferromagnetic resonance is found with an exceptionally low Gilbert damping coefficient. The large-area transfer of this highly strained complex oxide BFMO thin film presents enormous potential for the integration of many other multifunctional oxides onto new substrates for future magnetic sensors and memory devices.« less

Magnetic and ferroelectric oxide thin films have long been studied for their applications in electronics, optics, and sensors. The properties of these oxide thin films are highly dependent on the film growth quality and conditions. To maximize the film quality, epitaxial oxide thin films are frequently grown on single-crystal oxide substrates such as strontium titanate (SrTiO₃) and lanthanum aluminate (LaAlO₃) to satisfy lattice matching and minimize defect formation. However, these single-crystal oxide substrates cannot readily be used in practical applications due to their high cost, limited availability, and small wafer sizes. One leading solution to this challenge is film transfer.more » In this demonstration, a material from a new class of multiferroic oxides is selected, namely bismuth-based layered oxides, for the transfer. A water-soluble sacrificial layer of Sr₃Al₂O₆is inserted between the oxide substrate and the film, enabling the release of the film from the original substrate onto a polymer support layer. The films are transferred onto new substrates of silicon and lithium niobate (LiNbO₃) and the polymer layer is removed. These substrates allow for the future design of electronic and optical devices as well as sensors using this new group of multiferroic layered oxide films.« less